LitaElek 10pcs RGB 5050 LED Strip Corner Connector 10mm 4 pin RGB LED Tape L-Shape Connector Splitter LED Ribbon Right Angle Connector L Connector Adapter for SMD 5050 RGB LED Strip, White Rgb 5050 Led Corner Connector 02
LitaElek 10pcs RGB 5050 LED Strip Corner Connector 10mm 4 pin RGB LED Tape L-Shape Connector Splitter LED Ribbon Right Angle Connector L Connector Adapter for SMD 5050 RGB LED Strip, White
These L shape connectors are compatible with both non-waterproof and waterproof 10mm wide RGB 5050 LED strip lights. Installation Instructions: 1.Ensure your section of LED light strip is 10mm wide RGB 5050 LED strip and has four contacts (+, B, R and G) and all the contacts are dry and clean. 2.Open the white clasp of the connector. 3.If you have a waterproof LED strip, you should peel off silicon on the surface around soldering/Cutting line area, then insert the LED light strip into the clasp, with the 4 contacts of the led strip under the 4 prongs of the connector- make sure to match the + side of the strip to the + side of the clasp; If you have a non-waterproof LED strip, just insert the LED light strip into the clasp, with the 4 contacts of the led strip under the 4 prongs of the connector- make sure to match the + side of the strip to the + side of the clasp. 4.Close the clasp. Important note: If the LEDs flicker or do not light up, it is because there is poor contact between the L-shape connector and the LED strip. To solve the problem, please follow these steps: 01.Power on your LED strip. 02.Open all the caps of the L-shape connector. 03.Insert your LED strip into the connector, slightly pull and push your LED strip to adjust the contact point between the 4 copper contacts on your LED strip and the 4 prongs in the connector. If the LEDs still do not light up, please use your finger to press a little hard on the 4 prongs in the connector. 04. If the LEDs still do not light up, please adjust the contact point between the 4 copper contacts on the L-shape PCB board and the 4 prongs in the connector, until you see the LEDs light up. Then you can close all the caps of the connector. Package Includes 10x L shape connectors for 10mm wide RGB 5050 LED Strip
- Compatible with both Waterproof and Non-Waterproof SMD 5050 RGB LED strip lights. Not for SMD3528 RGB LED strip lights.
- 4 channel PCB chip with 2 easy-clasp connectors, Seamless extension for your RGB light strips around sharp corner
- Simple but effective, tool free, easy installation by clipping system, making neat and good looking LED strips turn corners, couldn't be any easier using these connectors
- With these L-shaped connectors, you can avoid twisting your led strips which potentially damages your LED strip.