FBHDZVV 5PCS 0.96 OLED Display Module 128x64 SSD1306 SPI 0.96 inch LED Driver Chip SSD1306 7Pin IIC I2C SPI Serial Yellow Blue Display Compatible with Arduino and Microcontroller DIY KIT
FBHDZVV 5PCS 0.96 OLED Display Module 128x64 SSD1306 SPI 0.96 inch LED Driver Chip SSD1306 7Pin IIC I2C SPI Serial Yellow Blue Display Compatible with Arduino and Microcontroller DIY KIT
Specification: Control chip: SSD1306 High resolution: 128 X 64 Viewing angle:> 160 ° Voltage: 3V ~ 5V DC Interface type: Default 4-wire SPI Switchable rear resistor to use 3-wire SPI, IIC interfaces Number of pins: 7 Working temperature: -30 -70°C Interface definition: GND - Power ground VCC - Power + 3.3-5V D0 - SPI clock line for SPI interface and IIC clock line for IIC interface D1 - SPI data line for SPI interface and IIC data line for IIC interface RES - OLED reset, OLED needs to be reset once after power-on DC - SPI data/command selection pin, used to set IIC address when IIC interface CS - OLED SPI chip select, active low, if you do not want to use must be grounded Wiring method: Wiring 1: MCU hardware SPI connection method: If there is only one device on the SPI bus, you can directly ground the CS of the OLED screen, which saves an IO. Wiring 2: MCU IO analog SPI connection mode: If there is only one device on the SPI bus, you can directly ground the CS of the OLED screen, which saves an IO. Wiring 3: MCU analog IIC connection method: IIC address: DC is low = 0x78 DC is high = 0x7A Generally DC grounding Wiring 4: MCU hardware IIC connection method: IIC address: DC is low = 0x78 DC is high = 0x7A Generally DC grounding Package Included: 5 X 0.96 Inch 7 pin OLED LCD display module 5 X Plastic stoage box
- OLED screen, internal drive chip: SSD1306, high resolution: 128X64 (and 12864LCD the same resolution, but the OLED screen more pixels per unit area), super wide viewing angle: more than 160 (maximum viewing angle display a screen).
- 0.96 OLED widely supply range: DC 3V-5V (without any changes, directly compatible with common 3.3V and 5V power supply system), ultra-low power consumption.
- 12864 oled 7 pin support for multiple operating modes: 3-wire SPI, 4 wire SPI, IIC.
- 0.96 inch SPI OLED display module low operating voltage and power consumption, self-emitting light,with chip select CS signal, you can achieve multiple SPI or IIC device on the same bus work.
- 0.96" OLED module supports many control chip : Fully compatible with Arduino, 51 Series, MSP430 Series, STM32 / 2, CSR IC, etc.