LitaElek 10pcs Solderless RGB LED Strip Connector Jumper 10mm wide 4-Pin Flex LED Ribbon LED Rope LED Tape Adapter Cable Connect RGB 5050 LED Strip Light to DC Power Supply,Controller- 17cm/6.7in Long
LitaElek 10pcs Solderless RGB LED Strip Connector Jumper 10mm wide 4-Pin Flex LED Ribbon LED Rope LED Tape Adapter Cable Connect RGB 5050 LED Strip Light to DC Power Supply,Controller- 17cm/6.7in Long
Connector adapter for 10mm wide 4 pin SMD 5050 RGB LED Light Strip- 6 Inch Long(10 pcs) Product Features : Connect your SMD 5050 RGB LED strip light to another LED strip light, dimmer, controller or power supply Simple, tool-free installation Installation Instructions: 1.Ensure your section of LED light strip has four contacts (+, B, R and G) and all the contacts all clean. 2.Open the white clasp of the connector. 3.If you have a waterproof LED strip, you should peel off silicon on the surface around soldering/Cutting line area, then insert the LED light strip into the clasp, with the 4 contacts of the led strip under the 4 prongs of the connector- make sure to match the + side of the strip to the + side of the clasp; If you have a non-waterproof LED strip, just insert the LED light strip into the clasp, with the 4 contacts of the led strip under the 4 prongs of the connector- make sure to match the + side of the strip to the + side of the clasp. 4.Close the clasp.Important note: If the LEDs flicker or do not light up, it is because there is poor contact between the connector and the LED strip. To solve the problem, please follow these steps: 01.Power on your LED strip. 02.Open all the caps of the connector. 03.Insert your LED strip into the connector, slightly pull and push your LED strip to adjust the contact points between the 4 copper contacts on your LED strip and the 4 prongs in the connector. If the LEDs still do not light up, please use your finger to press a little hard on the 4 prongs in the connector. Our connectors and extensions are fully bendable and are perfect for extending LED light strip across a gap, around an obstacle, or for making a bend. Package includes: 10x RGB 5050 LED Strip Connector Adapter Cable10x Male to Male 4-Pin Plugs
- Fits 10mm wide SMD 5050 RGB LED strips
- Connect your SMD 5050 RGB LED strip light to another LED strip light, dimmer, controller or power supply
- Easy to Install: No need to solder. Just clasp your prepared led strip section into the connector to get connected.
- Flexible & Durable: Each cable consists of 4 individaul wires, flexible and durable enough for bending or twisting in ANY ANGLES without breaking.