LED Strip Light Controller,SPIGHTDEX RF Mini Dimmer Single Channel LED Remote Smart Wireless Remote with Control N10
LED Strip Light Controller,SPIGHTDEX RF Mini Dimmer Single Channel LED Remote Smart Wireless Remote with Control
Read more Specifications Brightness grade:10 levels Brightness shortcut :4 levels Dynamic mode:8 modes Dynamic speed grade:10 levels Working voltage:DC 5-24V Remote frequency:433.92MHz Remote control distance:>15m at open area Rated output current:110A Wireless RF PWM LED Single Color Dimmer N10 single color LED controller is designed to drive constant voltage LED products in voltage range of DC5-24V. The main unit works with a RF remote controller, user can setup LED brightness and dynamic modes on the remote controller. The main unit is powered by DC power supply and receives remote controller commands to drive LED fixtures. Our dimmer with full protection function,for wrongwiring, output short circuit, overload and overheat. You can use it without any worry burn out in your house. 100%safe for using and protect ourselfe. Read more Read more Oh,No If you use the dimmer or controller which is without the auto protection function. we could get risk any time for burning the devices, and the will risk for us&our family. Full protection design Steady green:Normal working.Single green blink:Command received.Long single green blink:Mode or color cycle edge.Long single yellow blink:Brightness or speed limit.Red flash:Overload protection.Yellow flash:Over heat protection.Green flash 3 times:New remote controller paired. Copper connector for 10A Current Stronger copper connetors for bigger wire with 10A current connect, wattage connect 120W/12V. Put the remote wherever you want The remote has a magnet and even comes with a 3M adhesive steel tag to place the remote in a convenient location. Read more Pair a new remote You could pair a new remote controller to main unit by following steps: 1). Plug off the power of main unit and plug in again after more than 5 seconds. 2). Press ‘50%’ and ‘10%’ key simultaneously for about 3 seconds, in time of 10 seconds after the main unit powered. Easy Operation Install positive power cable into the terminal marked with ‘+’ and negative power cable into the terminal marked with ‘-’. The two positive jacks are connected inside the controller and same for the negative jacks. The controller can accept DC power from 5V to 24V, the output voltage is the same as the power supply, so please make sure the LED rated voltage is same as the power supply. Do not power on the controller until all connection is firmly finished. Friendly After-sales Service A hassle-free, friendly support experience with a team that's available via email, phone or online chat. Read more
- SMART LED STRIP CONTROLLER is our newly developed high-end Led controller controlled by wireless remote controller.Extra percentage shortcuts-100%,50%,25%,10%,helps you adjust directly and accurately.Merry Christmas!
- Effective range 50 feet-unlike traditional IR remotes.Each unit can be matched to 5 remote controllers / remote controller can be matched to any receiver.Overload protection and over heat protection.Provide comprehensive protection.
- RELIABLE RF REMOTE CONTROL works through most surfaces,3M paper magnetic iron sheet that can be attached to any metal (iron or iron-containing) object, can control LED light strip anywhere,CONVENIENT SAFE!
- Working Voltage:5V-24V;Total output Max:10A;The controller adopt high-end wireless technology with the features of low power consumption, long signal transmitting and strong anti-interference,ect.
- The controller is non-waterproof. Please avoid the sun and rain. When installed outdoors please ensure it is mounted in a water proof enclosure.